【お知らせ】3/28から4/1まで出張のため煙突と薪ストーブの出荷は出来ません。

New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304
New roof support bracket for outer diameter 200mm flat plate type SUS304

New roof support bracket for outer diameter 200mm flat plate type SUS304

Vendor
山のえんとつ屋
Regular price
¥15,000
Sale price
¥15,000
Regular price
Sold out
Unit price
per 
Shipping calculated at checkout.

It becomes a new roof support bracket.

If it was a normal one, it could not be supported without adding reinforcement to the nojiku board.

In addition, it was very difficult to support the roof bracket when a large hole was made in the roof.

If you use this, you can easily install it by drilling a hole in the roof board and covering it from above without any work such as reinforcement.

Or it will be installed from the ceiling behind the attic to the rafters.

The plate is made of SUS304 with a thickness of 2 mm, so unlike conventional products, it is possible to firmly support the chimney without falling down from the hole on the roof of the sheathing board.

We have confirmed that it can be used up to a 9 inch slope.

In order to use a rectangular slope (10-inch slope of 45 degrees), it was necessary to widen the elliptical hole in the plate.

Please refer to the photo with the curing tape applied.

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
T
Takeshi Maekawa
新型ルーフサポートブラケット(外径200ミリ用 フラットプレート型 SUS304製)

既設の飾り煙突に煙突用の穴を開けて本物の煙突にした際に使用しました。
煙突をしっかり支えてくれるので施工の際に大変助かりました。

保木 法菓堂
新型ルーフサポートブラケット

煙突類をこちらで全て購入させて頂きました。本体はエフェル社のストーブ。本体と問題なく入るサイズでした。
そして煙突を屋根で固定するルーフサポートは、穴の大きさをそんなに気にせずに施工できました。とても使い勝手の良い製品だと思います。
初めての煙突施工でしたが、疑問と質問がLINEでやり取りできる事が大変助かりました。継続的に煙突はこちらで購入して行こう思います。